Audi Workshop Service and Repair Manuals > A4 Mk2 > Body | General body repairs, interior | Seat frames | Rear seats | Removing and installing seat bench

Removing and installing seat bench - vehicles from 11.2004 onwards

Removing

–	Pull front edge of seat bench out of retainers -1- (left and right).

–	Disengage seat bench from retainers -4- (left and right) by pushing it firmly towards the rear.

–	On vehicles with seat heating raise the seat bench high enough to be able to unplug the electrical connectors.

–	Take electrical connector for side airbag out of groove → Fig..

–	Take seat bench out of vehicle.

Installing

Install in reverse order of removal. Observe the following:

Caution

The retainers must be renewed whenever you have removed the rear seat bench → Fig..

Side airbag connector

WARNING

Observe safety regulations for pyrotechnic components → Chapter.

Renewing retainers

–	Remove used retainer from body cut-out.

–	Fit new retainer -2- in body opening -1- and push it in until you hear it engage.

Audi Workshop Service and Repair Manuals