Audi Workshop Service and Repair Manuals > A4 Mk2 > Body | General body repairs, interior | Trim, noise insulation | Trim panels - Avant | Removing and installing rear lid trim | Removing and installing rear lid trim (bottom)

Removing and installing rear lid trim (bottom)

Special tools and workshop equipment required

t	Front-end hook -3370-

1 -	Luggage compartment light

q	Removing and installing → Electrical system; Rep. gr.96

2 -	Bolts (4x)

q	Tightening torque: 1.5 Nm

3 -	Rear lid trim (bottom)

Removing:

–	Open flap for warning triangle and detach warning triangle.

–	Unscrew bolts -2- (4x).

–	Disengage fasteners (left and right) at top of trim using front-end hook -3370- → Fig.

–	Carefully pull spring clips -4- of trim at bottom right and left out of rear lid.

–	Reach between trim and rear lid and disengage four more spring clips -4-.

–	Detach trim.

t	Installing:

Install in reverse order of removal. Observe the following:

–	Make sure trim engages in trim panel at rear lid lock.

Caution

Make sure trim is properly secured.

4 -	Spring clips (6x)

Disengaging trim (bottom) from fastener

–	Disengage fastener (left and right) at top of trim using front-end hook -3370--arrow-.

Audi Workshop Service and Repair Manuals