–
| Release cable bracket, unplug speed sensor connector -1- and press out grommet (left and right sides are the same). |
Installation is carried out in reverse sequence. |
–
| Before installing, lubricate seal for speed sensor all round with lubricating paste -G 000 650-. |
–
| Unscrew speed sensor from wheel bearing housing. |
–
| Check that rotor is not damaged or dirty. |
Removing and installing rotor on rear axle |
–
| Remove the brake caliper |
–
| Hang up brake caliper on body. |
–
| Check that rotor is not damaged or dirty. |
–
| If rotor is damaged, remove and renew wheel hub together with rotor. |
Installation is carried out in reverse sequence. |
–
| Route speed sensor wire back in original position - see removal. |
–
| Before installing, lubricate seal for speed sensor all round with lubricating paste -G 000 650-. |
|
|
|