audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Removing and installing operating and display unit, Climatronic control unit J255 > < Possible cause of odour formation
Cleaning evaporator
Cleaning evaporator
  Note
Cleaning of the evaporator with the ultrasonic air conditioner cleaning unit -VAS 6189- is illustrated in VW - Audi TV programme no. 201 → Audi Service Net VW - Audi TV programme no. 201.
Tools required
t  Ultrasonic air conditioner cleaning unit -VAS 6189-
t  Cleaning fluid -VAS 6189/1-
Preparation
–  By switching from fresh air to recirculated-air mode, check whether the air conditioner unit evaporator is really the source of the odour.
  Note
The odour can only be eliminated by cleaning with the ultrasonic air conditioner cleaning unit -VAS 6189- if it actually occurs in the evaporator.
–  Check the plenum chamber and the water drain valves fitted in it and clean these if necessary.
–  Check for odour from and contamination of dust and pollen filter → Chapter.
  Note
On this vehicle, the dust and pollen filter is installed at the intake housing of the air conditioner unit upstream of the fresh air blower -V2- and does not therefore have to be removed for cleaning.
–  Start engine.
–  On the operating and display unit, Climatronic control unit -J255-, set “recirculated-air mode” and switch off the compressor “Econ mode”.
–  Open the dash panel vents and, on the operating and display unit, Climatronic control unit -J255-, set the lowest possible temperature for the driver's and front passenger's side (e.g. “Lo” temperature setting).
–  Close the vehicle windows and sun roof.
–  Select the lowest fresh air blower speed on the operating and display unit, Climatronic control unit -J255- and set the air outflow direction to the “dash panel vents”.
Cleaning
–  Shake the bottle of cleaning fluid -VAS 6189/1- and pour the fluid into the ultrasonic air conditioner cleaning unit -VAS 6189-. In doing so, heed the operating instructions for the ultrasonic air conditioner cleaning unit -VAS 6189-.
–  Position the ultrasonic air conditioner cleaning unit -VAS 6189- in the passenger's footwell.
–  Start up the ultrasonic air conditioner cleaning unit -VAS 6189- (in accordance with the appropriate operating instructions) and position the outlet hose such that the vapour emerging is drawn in by the fresh air blower -V2- via the recirculated-air opening of the air conditioner unit (in the passenger's footwell behind the glove box).
–  Close the vehicle doors.
  Note
The cleaning process takes roughly 15 to 20 minutes and is completed when no further vapour emerges from the outlet hose.
Concluding operations
–  Switch off the ultrasonic air conditioner cleaning unit -VAS 6189-.
–  Open the vehicle doors and vent the vehicle for at least 10 minutes.
–  Remove the ultrasonic air conditioner cleaning unit -VAS 6189- from the vehicle and clean it in line with the appropriate operating instructions.
–  Switch off ignition.
   

Removing and installing operating and display unit, Climatronic control unit J255 > < Possible cause of odour formation