A4 Mk2
Note
|
| 1 - | Housing with heat exchanger |
| q | Not to be dismantled |
| q | Remove combustion residue from combustion chamber prior to assembly (clean) |
| q | Affixing auxiliay heater rating plate in line with auxiliary heater design (for “Petrol” or “Diesel”) → Chapter |
| 2 - | Burner element with combustion air blower -V6- |
| q | Checking → Chapter |
| q | Removing and installing → Chapter |
| q | Dismantling and assembling → Chapter |
| q | Affixing auxiliay heater rating plate in line with auxiliary heater design (for “Petrol” or “Diesel”) → Chapter |
| q | Do not pull on impeller of combustion air blower to remove → Chapter |
| q | Can only be pulled out of housing following removal of glow plug for heater -Q9- → Chapter |
| 3 - | Top part of housing with intake air duct |
| 4 - | Bolt |
| 5 - | “Auxiliary heater” wiring harness |
| q | With various sensors |
| q | Version for vertical installation |
| 6 - | Cover for auxiliary heater sensors |
| q | Holds temperature sensor -G18- in position in auxiliary heater |
| q | Detaching and attaching → Chapter |
| 7 - | Hexagon nut |
| q | Special collared nut |
| 8 - | Hexagon nut |
| q | Self-locking, replace |
| q | For attachment of wiring harness earth connection |
| 9 - | Glow plug for heater -Q9- |
| q | With internal heater coils |
| q | Checking → Chapter |
| q | Removing and installing → Chapter |
| 10 - | 2-pin connector |
| q | To circulation pump -V55- |
| 11 - | Heater overheating fuse -S24- |
| q | Checking → Chapter |
| q | Removing and installing → Chapter |
| q | Part of wiring harness, cannot be replaced separately |
| 12 - | Auxiliary heater earth connection |
| q | Current flows back via this connection from glow plug to auxiliary heater control unit -J364- |
| q | Check for corrosion (contamination) and firm attachment to housing |
| 13 - | Temperature sensor -G18- |
| q | Checking → Chapter |
| q | Removing and installing → Chapter |
| q | Part of wiring harness, cannot be replaced separately |
| q | Positioned directly in coolant and sealed off from housing by way of an O-ring |
| 14 - | O-ring |
| q | Replace |
| 15 - | 2-pin connector |
| q | To combustion air blower -V6- |
| q | Inserted in burner element |
| 16 - | Flame monitor -G64- |
| q | Checking → Chapter |
| q | Removing/installing and checking → Chapter |
| q | Part of wiring harness, cannot be replaced separately |
