audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Cleaning ATF pipes and ATF cooler > < Removing and installing ATF pipes

A4 Mk2

Removing and installing auxiliary ATF cooler
Removing and installing auxiliary ATF cooler
Special tools and workshop equipment required
   
t  Used oil collection and extraction unit -V.A.G 1782-
  W00-10211
Removing
–  Remove front right wheel housing liner → Rep. Gr.66.
–  If fitted, remove charge air cooler → Rep. Gr.21.
–  Remove bolts -arrows A- and -arrow B-
  A37-0490
–  Remove bolt -arrow-.
–  First pull ATF pipe -1- out of auxiliary ATF cooler, then ATF pipe -2-.
–  Detach auxiliary ATF cooler
Installing
Installation is carried out in reverse sequence; note the following:
–  First insert ATF pipe -2- all the way into auxiliary ATF cooler, then ATF pipe -1-.
–  Screw in bolt -arrow- hand-tight.
  A37-0489
–  Fit pin on auxiliary ATF cooler -arrow C- onto mounting of charge air cooler.
–  Tighten bolts:
A - M6x17 bolts - 10 Nm
B - M6x10 bolt - 5 Nm
–  Install charge air cooler → Rep. Gr.21.
–  Install front wheel housing liner → Rep. Gr.66.
–  Check and top up ATF level in planetary gearbox → Chapter.
Tightening torque
  A37-0490
ComponentNm
ATF pipes to auxiliary ATF cooler25

   

Cleaning ATF pipes and ATF cooler > < Removing and installing ATF pipes