audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing speedometer sender G22 > < Renewing oil seal for selector shaft

A4 Mk2

Removing and installing multifunction switchF125
Removing and installing multifunction switch -F125-
   
Removing
–  Remove front left wheel.
–  Vehicles with 2.5 ltr. TDI engine: detach drive shaft noise insulation (left-side) from wheel housing -arrows-.
–  Remove gearbox support (left-side) → Chapter.
  N37-0481
–  Detach electrical connector -1- at multifunction switch -F125-.
  Note
-Item 2- can be disregarded.
  N37-0480
–  Remove multifunction switch -F125--arrows-.
–  Pull multifunction switch -F125- off selector shaft.
  A37-0268
Installing
Installation is carried out in reverse sequence; note the following:
–  Fit multifunction switch -F125- onto selector shaft. The flat surface in the splines of the switch -3- must coincide with the flat surface on the selector shaft -1-.
  Note
Fit the multifunction switch -F125- centrally on the selector shaft. Take care to keep it straight and do not use excessive force. This could damage the switch contacts.
–  Turn switch so that drilling -4- on switch housing can be fitted on locating pin -2- on gearbox housing.
–  Install gearbox support (left-side) → Chapter.
–  Install front left wheel → Rep. Gr.44.
Tightening torque
  A38-0020
ComponentNm
Multifunction switch -F125- to gearbox8

   

Removing and installing speedometer sender G22 > < Renewing oil seal for selector shaft