t
| To install the selector lever handle -3- the button -2- has to be pulled out to the stop and must be secured with either a cable tie -arrow- or with the assembly aid supplied together with the new handle. |
t
| If, by mistake, the button has not been secured, it must not be pulled out of the selector lever handle using mechanical tools. Position a compressed air gun at the bottom of the handle and press the button out with compressed air. |
–
| Fit selector lever handle -3- fully onto selector lever; button -2- points towards the driver. The handle must engage in the annular groove on the selector lever. |
–
| Remove the cable tie -arrow- or assembly aid; the button mechanism will then engage in the vertical groove on the selector lever. If necessary, press the button into the selector lever handle. |
–
| Pull sleeve -1- upwards and clip it in by turning it to the right. |
|
|
|