Audi Workshop Service and Repair Manuals > A4 Mk2 > Power transmission | Servicing multitronic 01J and 0AN | Automatic gearbox, gears, control | Servicing input shaft with 6 friction plates

Servicing input shaft with 6 friction plates

Caution

t	If the wrong number of friction plates is installed during servicing, the input shaft will be damaged when the vehicle is re-started.

t	In such cases, there is a mismatch between the software configuration on the automatic gearbox control unit -J217- and the number of friction plates in the clutch pack.

There are two types of gearbox. The → Electronic parts catalogue also distinguishes between these on the basis of the gearbox code letters:

1. Gearboxes which are serviced with 7 friction plates

These gearboxes are installed in vehicles with the following engines:

TDI engines:	4-cyl. 1.9l TDI engine	4-cyl. 2.0l TDI engine	6-cyl. 2.5l TDI engine	6-cyl. 2.7l TDI engine
Petrol engines:	6-cyl. 3.0l MPI petrol engine	6-cyl. 3.2l FSI petrol engine	6-cyl. 2.8l FSI petrol engine	4-cyl. 2.0l TFSI engine

t	→ Chapter „Exploded view - input shaft with 7 friction plates“

t	→ Chapter „Dismantling and assembling input shaft with 7 friction plates“

2. Gearboxes which are serviced with 6 friction plates

These gearboxes are fitted on vehicles with all other engines (except the engines listed under 1.).

t	→ Chapter „Exploded view - input shaft with 6 friction plates“

t	→ Chapter „Dismantling and assembling input shaft with 6 friction plates“

Audi Workshop Service and Repair Manuals