A4 Mk2
|
Caution
| 1 - | Oil seal for input shaft |
| q | Renewing → Chapter |
| 2 - | Retaining ring for input shaft cover |
| q | Replace with one of same thickness |
| 3 - | Input shaft cover |
| q | After removing the cover, the bearing “A” (ball bearing for input shaft) in the input shaft cover must be replaced → Chapter |
| 4 - | Piston |
| q | Wear assessment procedure → Chapter |
| 5 - | Pressure plate |
| q | Wear assessment procedure → Chapter |
| 6 - | Corrugated washer |
| 7 - | Upper shim |
| q | Determining thickness → Chapter |
| q | Renew |
| 8 - | Friction plate |
| q | 6x |
| q | Renew |
| 9 - | Outer plate |
| q | 5x |
| q | Renew |
| 10 - | Lower shim |
| q | Determining thickness → Chapter |
| q | Renew |
| 11 - | Input shaft cylinder |
| q | Wear assessment procedure → Chapter |
| 12 - | O-ring |
| q | Renew |
| 13 - | Oil pipe |
| q | Wear assessment procedure → Chapter |
