audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exhaust system > < Removing and installing charge air cooler

A4 Mk2

Removing and installing charge pressure senderG31 with intake air temperature senderG42
Removing and installing charge pressure sender -G31- with intake air temperature sender -G42-
   
Removing
–  Remove cover -arrow- at power steering fluid reservoir.
  A10-1160
–  Remove air intake hose -1- from charge air cooler.
–  Detach electrical connector -2- at charge pressure sender -G31- / intake air temperature sender -G42-.
–  Remove bolts and pull charge pressure sender -G31- / intake air temperature sender -G42- out of charge air cooler.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Renew O-ring.
Tightening torques
  A21-0156
ComponentNm
Charge pressure sender -G31-/intake air temperature sender -G42- to charge air cooler5
Hose clips (9 mm wide)3
Hose clips (13 mm wide)5.5

   

Exhaust system > < Removing and installing charge air cooler