A4 Mk2
| Sealing flanges and flywheel - exploded view |
| 1 - | Sealing flange (front) |
| q | Must be positioned on dowel sleeves |
| q | Apply sealant when installing; refer to → Electronic parts catalogue |
| q | Removing and installing: vehicles up to 05.2003 → Chapter; vehicles from 06.2003 onwards → Chapter |
| 2 - | 15 Nm |
| 3 - | Oil seal |
| q | Renewing → Chapter |
| 4 - | Sump |
| q | Removing and installing → Chapter |
| 5 - | 15 Nm |
| 6 - | Cylinder block |
| q | Removing and installing crankshaft → Chapter |
| q | Dismantling and assembling pistons and conrods → Chapter |
| 7 - | Dual-mass flywheel or damper unit for multitronic gearbox |
| q | Removing and installing dual-mass flywheel → Chapter „Removing and installing dual-mass flywheel - vehicles with manual gearbox“ |
| q | Removing and installing flywheel → Chapter „Removing and installing flywheel - vehicles with multitronic gearbox“ |
| q | Removing and installing damper unit for automatic gearbox → Rep. Gr.13 |
| 8 - | Securing bolt for dual-mass flywheel/damper unit |
| q | Renew |
| q | Tightening torque: vehicles with manual gearbox → Anchor; vehicles with multitronic gearbox → Anchor |
| 9 - | Intermediate plate |
| q | Must be positioned on dowel sleeves |
| q | Do not damage/bend when assembling |
| q | Is fitted onto sealing flange → Fig. |
| q | On vehicles with four-wheel drive, an intermediate (plate thickness 5.5 mm) must additionally be fitted |
| 10 - | 15 Nm |
| 11 - | Sealing flange (rear) with oil seal |
| q | With gasket for cylinder block |
| q | A sealing flange with an oil seal in offset position is supplied as a replacement part |
| q | Removing and installing → Chapter |
| q | Apply sealant when installing; refer to → Electronic parts catalogue |
| q | To install, push guide sleeve from installation kit onto crankshaft |
|
|
