audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing cylinder head > < Cylinder head - exploded view

A4 Mk2

Removing and installing cylinder head cover
Removing and installing cylinder head cover
   
Removing
–  Pull off engine cover panel -arrows-.
  A10-10294
–  Remove bolts -arrows-.
–  Remove air ducts -1- and -2-.
  A10-0746
–  Remove top toothed belt cover by releasing retaining clips -arrows-.
  A13-0665
–  Detach crankcase breather hose and vacuum hose from cylinder head cover -arrows-.
–  Remove cylinder head cover bolts in the sequence -11 ... 1-.
–  Remove cylinder head cover.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Renew gasket for cylinder head cover and bolts if damaged.
–  Tighten bolts for cylinder head cover to final setting in the sequence -1 ... 11-.
Tightening torque
  A15-10346
ComponentNm
Cylinder head cover to cylinder head10

   

Removing and installing cylinder head > < Cylinder head - exploded view