A4 Mk2
Sump, oil pump, balance shaft assembly with chain drive - exploded view |
1 - | Sump |
q | Removing and installing → Chapter |
2 - | 23 Nm |
3 - | Torque reaction support |
4 - | 10 Nm |
5 - | Intake connecting pipe |
q | Clean strainer if dirty |
6 - | 10 Nm |
7 - | O-ring |
q | Renew |
8 - | Oil pump |
q | Removing and installing → Chapter |
q | Before installing, check that the two dowel sleeves for centring oil pump are fitted onto balance shaft assembly. |
9 - | Oil pump drive shaft |
10 - | Circlip |
q | Must fit securely in groove |
q | Renew circlip if damaged or stretched |
11 - | Chain sprocket for balance shaft assembly |
12 - | 10 Nm + 90° (1/4 turn) further |
q | Renew |
q | Tighten with chain tensioner released |
13 - | Chain sprocket cover |
14 - | 5 Nm |
q | Apply locking fluid when installing; refer to → Electronic parts catalogue |
15 - | 9 Nm |
q | Observe correct tightening sequence → Chapter |
16 - | Fitted bolt, 20 Nm |
q | Part of chain tensioner |
q | Observe correct tightening sequence → Chapter |
17 - | Chain tensioner |
q | Do not dismantle |
q | Removing and installing → Chapter |
18 - | Drive chain for balance shaft assembly |
q | Mark direction of rotation before removing |
q | Check for wear |
q | Removing and installing → Chapter |
19 - | Drive chain sprocket for balance shaft assembly |
q | Converting balance shaft assembly to spur gear drive → Chapter |
20 - | Balance shaft assembly |
q | Removing and installing → Chapter |
q | Before installing, check that the two dowel sleeves for centring balance shaft assembly are fitted onto cylinder block. |
21 - | M7 = 13 Nm + 90° (1/4 turn) further; M8 = 20 Nm + 90° (1/4 turn) further |
q | Renew |
q | Observe correct tightening sequence → Chapter |
22 - | Oil intake pipe |
23 - | 10 Nm |
24 - | 40 Nm |
q | Observe correct tightening sequence → Anchor |
25 - | 45 Nm |
q | Observe correct tightening sequence |
26 - | 15 Nm |
q | Tighten in stages and in diagonal sequence |
q | Observe correct tightening sequence |
27 - | Seal |
q | Renew |
28 - | Oil drain plug, 30 Nm |
|
|