A4 Mk2
Poly V-belt drive for power steering pump, alternator and air conditioner compressor - exploded view |
1 - | Poly V-belt |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen |
q | Check for wear |
q | Removing and installing → Chapter |
2 - | 22 Nm |
3 - | 45 Nm |
4 - | 22 Nm |
5 - | Bracket for alternator |
6 - | Alternator |
q | Removing and installing → Electrical system; Rep. Gr.27 |
7 - | 55 Nm |
8 - | 22 Nm |
9 - | Pulley for power steering pump |
q | To remove and install: counterhold with pin wrench -3212- → Fig. |
q | Marked “Vorne/Front” |
10 - | 10 Nm |
11 - | Pressure hose to power steering |
12 - | Banjo bolt, 47 Nm |
13 - | Seals |
q | Renew |
14 - | Power steering pump with bracket |
q | Removing and installing → Running gear, front-wheel drive and four-wheel drive; Rep. Gr.48 |
15 - | Supply hose |
q | From reservoir |
16 - | 22 Nm |
17 - | Tensioner for poly V-belt |
18 - | Pulley for crankshaft |
q | Removing and installing → Chapter |
19 - | 25 Nm |
20 - | Air conditioner compressor |
q | Do not unscrew or disconnect refrigerant hoses or pipes. |
q | After detaching compressor from mountings, secure it to body with wire or similar. Do not leave it suspended from refrigerant pipes. |
21 - | 22 Nm |
|