Audi Workshop Service and Repair Manuals > A4 Mk2 > Power unit | 6-cylinder TDI engine (2.7 ltr.; 3.0 ltr. 4-valve common rail), mechanics | Engine cooling | Cooling system | Removing and installing radiator fan (right-side)

Removing and installing radiator fan (right-side)

Special tools and workshop equipment required

t	Removal lever -80 - 200-

Removing

Note

All cable ties which are released or cut open when removing must be fitted in the same position when installing.

–	Move lock carrier to service position → Chapter.

–	Unplug electrical connector -arrow-.

–	Move clear electrical wiring for radiator fan (right-side).

–	Remove securing bolt -1-.

–	Turn radiator fan assembly (right-side) in direction of -arrow- and remove.

Installing

Install in reverse order.

Note

t	Hose connections and hoses for charge air system must be free of oil and grease before assembly.

t	Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.

t	To ensure that the charge air hoses can be properly secured at their connections, spray rust remover onto the worm thread of used hose clips before installing.

t	Fit all cable ties in the original positions when installing.

–	Install lock carrier with attachments → Rep. gr.50.

–	Install bumper cover (front) → Rep. gr.63.

Tightening torques

Component		Nm
Retaining bolt for radiator fan (right-side)		4.5
Hose clips	Width 9 mm	3
	Width 13 mm	5.5

Audi Workshop Service and Repair Manuals