A4 Mk2
Note
|
| 1 - | Connecting pipe for exhaust gas recirculation |
| 2 - | Intake connecting pipe |
| 3 - | Gasket |
| q | Renew |
| 4 - | Bolt |
| q | 9 Nm |
| q | Tighten in stages and in diagonal sequence |
| 5 - | Bolt |
| q | 9 Nm |
| 6 - | Bolt |
| q | 9 Nm |
| 7 - | Intake manifold (top section) |
| q | Removing and installing |
| 8 - | Bolt |
| q | 9 Nm |
| 9 - | Gasket |
| q | Renew |
| 10 - | Retaining pin |
| q | For engine cover |
| q | 5 Nm |
| 11 - | Intake manifold flap motor |
| q | Cylinder bank 1 (right-side): intake manifold flap motor -V157- |
| q | Cylinder bank 2 (left-side): intake manifold flap 2 motor -V275- |
| q | Removing and installing → Chapter |
| 12 - | Bolt |
| q | Do not loosen |
| 13 - | Securing clip |
| q | Do not dismantle |
| 14 - | Connecting rod |
| 15 - | Coupling |
| 16 - | Bottom section of intake manifold (left-side) |
| q | Removing and installing → Chapter |
| q | Removing and installing bottom section of intake manifold (right-side) → Chapter |
| 17 - | Gasket |
| q | Renew |
| 18 - | Bolt |
| q | 9 Nm |
| 19 - | Screw plug |
| q | 10 Nm |
| 20 - | Seal |
| q | Renew |
| 21 - | Bolt |
| q | 9 Nm |
| 22 - | Seal |
| q | Renew |
| 23 - | Throttle valve module -J338- |
| 24 - | Bolt |
| q | 9 Nm |
| 25 - | Intake connecting pipe |
| 26 - | Seal |
| q | Renew |
| 27 - | Bolt |
| q | 9 Nm |
| 28 - | Gasket |
| q | Renew |
