audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Exploded view for 6-cyl. petrol engine (MPI) > < Power steering pump, reservoir and hydraulic pipes: exploded view
Exploded view for vehicles with 4-cyl. engine, 6-cyl. petrol engine (FSI) and 6-cyl. diesel engine
Exploded view for vehicles with 4-cyl. engine, 6-cyl. petrol engine (FSI) and 6-cyl. diesel engine
There is no provision for repairing the power steering pump. If problems are reported, trace the fault by means of a pressure test and a leakage test. Renew the power steering pump if there is a fault.
The hydraulic fluid circuit on right-hand drive vehicles is the same as on left-hand drive vehicles, except that the hydraulic pipes are extended from left to right on the steering box.
  Note
t  Always check steering system for leaks if fluid level is low in reservoir.
t  If leakage is visible at the pipe connections first tighten connections and wipe dry, then check for leaks again.
t  Replacement pumps are not filled with fluid. Therefore it is essential to fill pump with hydraulic fluid and to rotate pump by hand prior to installation. Otherwise pump can be damaged or may be noisy during operation.
t  For correct type of fluid refer to → Parts catalogue.
   
1 - Power steering box
q   For correct version refer to → Parts catalogue
2 - Return hose
3 - Expansion hose
4 - Cap with dipstick
q   Checking fluid level → Chapter
5 - Hexagon bolt, 9 Nm
6 - Reservoir
q   Use hydraulic fluid → Parts catalogue when filling system
7 - Rubber mounting
8 - Hose clip
q   Use -V.A.G 1275- to tighten
q   Always renew
9 - Return hose
q   Between reservoir and cooling pipe
10 - Hose clip
q   Use -V.A.G 1275- to tighten
q   Always renew
11 - Hexagon bolt, 10 Nm
12 - Cooling pipe
13 - Cable tie
14 - Hose clip
q   Use -V.A.G 1275- to tighten
q   Always renew
15 - Suction hose
q   Installation position → Chapter
16 - Hose clip
q   Use -V.A.G 1275- to tighten
q   Always renew
17 - Power steering pump
q   For 6-cyl. diesel engine and 6-cyl. petrol engine (FSI)
q   For correct version refer to → Parts catalogue
q   Fill with fluid before installing ⇒ Note → Chapter
18 - Seal
q   Always renew
19 - Seal
q   Always renew
20 - Banjo bolt, 50 Nm
21 - Power steering pump
q   For 4-cyl. engine
q   Fill with fluid before installing ⇒ Note → Chapter
22 - Seal
q   Always renew
23 - Seal
q   Always renew
24 - Banjo bolt, 50 Nm
25 - Suction hose
q   Installation position → Chapter
26 - Hose clip
q   Use -V.A.G 1275- to tighten
q   Always renew

   

Exploded view for 6-cyl. petrol engine (MPI) > < Power steering pump, reservoir and hydraulic pipes: exploded view