audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Power steering box > < Removing and installing steering column

A4 Mk2

Removing and installing steering lock with ignition/starter switch (without lock cylinder)
Removing and installing steering lock with ignition/starter switch (without lock cylinder)
Special tools and workshop equipment required
t  Torque wrench -V.A.G 1331-
Removing
–  Remove steering column → Chapter.
   
–  Chisel off shear bolt
  Note
t  Steering column must be clamped in a vice when chiseling out shear bolts.
t  The steering column mounting bracket will be damaged if work is performed with the steering column in the vehicle.
–  Remove lock cylinder → Rep. Gr.94.
–  Take off steering lock with ignition/starter switch (without lock cylinder).
Installing
–  Position steering lock with ignition/starter switch (without lock cylinder) on steering column and screw in shear bolts.
–  Install lock cylinder → Rep. Gr.94.
–  Tighten shear bolt to 20 Nm.
The bolt head should shear off when this torque range is applied.
The remaining installation steps are carried out in the reverse sequence.
–  Install steering column → Chapter.
  A48-0365

Power steering box > < Removing and installing steering column