A4 Mk3
| Exploded view - side member trim |
| Removing and installing side member trim |
| 1 - | Side member trim |
| – | To remove, unscrew bolts (bottom). |
| – | Starting at front and working from bottom to top, pull side member trim off velcro strip on fastening strip. |
| – | When installing, first engage trim at top of fastening strip. |
| – | Press top of trim into velcro strip and secure bottom of trim with bolts. |
Note| If the old side member trim is re-installed, renew the adhesive strips → Special catalogue, Chemical materials. |
| 2 - | Clip |
| 3 - | Bolt |
| q | 1.5 Nm |
| 4 - | Adhesive tape |
| q | Supplied together with new parts |
| q | Must be renewed when re-installing side member trim → Special catalogue, Chemical materials |
| 5 - | Velcro strip |
| Renewing fastening strip |
| 1 - | Fastening strip |
| – | Unscrew nuts and detach fastening strip. |
| – | Before installing, peel off protective film, align fastening strip according to body contour and press on firmly. |
| 2 - | Stud |
| 3 - | Adhesive tape |
| 4 - | Nut |
| q | 2 Nm |
|
|
