A4 Mk3
| Exploded view - exterior door handle and door lock |
| 1 - | Exterior door handle |
| q | Removing and installing → Chapter |
| 2 - | Bolt |
| q | 2.5 Nm |
| 3 - | Backing plate (front) |
| q | Removing and installing → Chapter „Removing and installing exterior door handle“ |
| 4 - | Backing plate (rear) |
| q | Removing and installing → Chapter „Removing and installing exterior door handle“ |
| 5 - | Housing |
| q | Instead of lock cylinder |
| q | For front passenger's door |
| q | Removing and installing: same procedures as for lock cylinder |
| 6 - | Bolt |
| q | Tightening torque → Item |
| 7 - | Cap |
| q | Unclip before removing door handle |
| 8 - | Door lock |
| 9 - | Bolt |
| q | 3.5 Nm |
| 10 - | Cover |
| q | With cover for door lock |
| q | Removing and installing → Chapter |
| 11 - | Mounting bracket |
| q | Removing and installing → Chapter |
| 12 - | Operating cable |
| q | For door lock |
| q | Removing and installing → Chapter |
| 13 - | Lock cylinder |
| q | Only for driver's door |
| q | Removing and installing → Chapter |
| 14 - | Magnet |
| q | Only for vehicles with Keyless Entry system |
| 15 - | Cap |
| q | Driver side: for lock cylinder |
| q | Passenger side: closed design |
| q | Removing and installing → Anchor |
| 16 - | Trim for exterior door handle |
| q | For vehicles without Keyless Entry system |
| q | Removing and installing → Chapter |
| 17 - | Door handle touch sensor |
| q | For vehicles with Keyless Entry system |
| q | Removing and installing → Rep. gr.96 |