Note | After a motor has been removed and re-installed or renewed, the motor must be adapted so that the sliding/tilting sunroof can operate properly. |
| –
| Switch on ignition and, if open, close doors and sunroof. |
| –
| Pull operating switch for sliding/tilting sunroof and hold in this position for 10 seconds. |
| –
| The sunroof panel will move to the tilted position, then it will run to the fully open position; subsequently it will return to the front tilted position and finally move back to the closed position. |
| t
| During the entire adaption process the operating switch for the sliding/tilting sunroof must be kept pulled. |
| t
| The adaption has now been completed. |
Note | If new replacement motors have been installed, the adaption begins immediately after the operating switched is pressed/pulled (not after 10 seconds). |
|
|
|
