Audi Workshop Service and Repair Manuals > A4 Mk3 > Body | General body repairs, exterior | Sliding roof | Sunroof (saloon) | Checking and adjusting zero position (slotted guide)

Checking and adjusting zero position (slotted guide)

Checking

Zero position can be checked with sunroof panel fitted.

–	Bellows removed

–	Retract sunroof panel and close again.

–	On vehicles with glass panel, push back sliding headliner as far as it will go.

–	Close sunroof.

–	If zero position is correct, guide pin -1- in tilt arm must be centrally aligned with marking -arrow- on slotted guide -2-.

Adjusting

–	Sunroof motor removed

–	Sunroof panel removed

–	Slide slotted guide on both sides into zero position by hand (as shown).

–	Adjust motor to zero position and install.

Audi Workshop Service and Repair Manuals