Audi Workshop Service and Repair Manuals > A4 Mk3 > Body | General body repairs, interior | Seat frames | Rear seat

Removing and installing inner bearing

Removing

–	Remove 2/3 section (right-side) and 1/3 section (left-side) of split backrest → Chapter.

–	Prise off cover -4-.

Note

For greater clarity, padding with cover is not shown in illustration.

–	Unscrew bolt -3- from backrest pan -1-.

–	Pull grommet -2- off bolt.

Installing

Install in reverse order of removal.

Tightening torques → Fig.

Audi Workshop Service and Repair Manuals