audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing rear speed sensors -G44- / -G46- > < Speed sensors of ABS/ESP system - overview

A4 Mk3

Removing and installing front speed sensors -G45- / -G47-
Removing and installing front speed sensors -G45- / -G47-
  Note
The sensor ring/rotor is incorporated in the corresponding wheel bearing unit and cannot be renewed.
Removing
–  Raise the vehicle.
   
–  Release connector -1- at speed sensor and unplug.
–  Remove bolt -2-.
–  Pull speed sensor out of wheel bearing housing.
Installing
Installation is performed in reverse sequence; note the following:
–  Before inserting speed sensor, clean inner surface of hole and coat speed sensor thoroughly with lubricating paste G 000 650.
–  After installation, turn steering to full left and right lock and check clearance of speed sensor wire.
–  Lower vehicle.
  A45-10095

Removing and installing rear speed sensors -G44- / -G46- > < Speed sensors of ABS/ESP system - overview