audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Exploded view - clutch hydraulics > < Removing and installing clutch pedal

A4 Mk3

Exploded view - pedal cluster (RHD vehicles)
Exploded view - pedal cluster (RHD vehicles)
  Caution
Risk of malfunction
The travel of the clutch pedal and the brake pedal must not be restricted due to additional floor mats or the like.
   
  Note
t  Apply grease -G 000 450 02- to all bearings and contact surfaces.
t  Make sure that no brake fluid escapes into the footwell, the plenum chamber or onto the gearbox below. If this does happen, clean the affected area thoroughly.
1 - Clutch pedal
2 - Clutch pedal stop
3 - Locking pin
q   For clutch master cylinder
4 - Bearing bush
5 - Pivot pin for clutch pedal
6 - Retaining clip
7 - Bearing
q   Note different bearing positions in clutch pedal → Anchor
8 - Bearing shell
9 - Over-centre spring
q   Black side points towards clutch pedal
q   Note different bearing positions in clutch pedal → Fig.
q   For correct version, refer to → Electronic parts catalogue
q   Remove and install with assembly clip -T40025-
10 - Bearing shell
11 - Seal
q   Renew
12 - Clutch position sender -G476-
q   Clutch pedal switch -F36- and clutch pedal switch for engine start -F194- are integrated
q   Can only be renewed together with clutch master cylinder → Item
13 - Clutch master cylinder
14 - Mounting bracket
q   With brake pedal
15 - Seal
16 - Retaining clip
17 - Bearing bush
18 - Bolt
q   2x
q   8 Nm

   
Installing over-centre spring
–  Clip bearing -1- into corresponding position on clutch pedal.
  A34-10639
Bearing positionVehicles with:
l  „I“-arrow A-:
t  Vehicles with 6-cyl. TDI engine
l  „II“-arrow B-
t  Not used on vehicles with »0B3 gearbox«

–  Insert over-centre spring with assembly clip -T40025-.
l  White side of over-centre spring faces bearing -1-.
   

Exploded view - clutch hydraulics > < Removing and installing clutch pedal