audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing over-centre spring > < Servicing clutch mechanism

A4 Mk3

Exploded view - pedal cluster (LHD vehicles)
Exploded view - pedal cluster (LHD vehicles)
  Caution
Risk of malfunction
The travel of the clutch pedal and the brake pedal must not be restricted due to additional floor mats or the like.
  Note
t  Apply grease -G 000 450 02- to all bearings and contact surfaces.
t  Make sure that no brake fluid escapes into the footwell, the plenum chamber or onto the gearbox below. If this does happen, clean the affected area thoroughly.
   
1 - Mounting bracket
q   With brake pedal
q   Removing and installing → Chapter
2 - Bearing bush
3 - Clutch pedal
q   Removing and installing → Chapter
4 - Clutch pedal stop
5 - Locking pin
q   For clutch master cylinder
6 - Pivot pin for clutch pedal
7 - Bearing shell
q   Located in clutch pedal
8 - Over-centre spring
q   Black side points towards clutch pedal
q   Note different bearing positions in mounting bracket → Anchor
q   Removing and installing → Chapter
q   For correct version, refer to → Electronic parts catalogue
9 - Bearing shell
q   Note different bearing positions in mounting bracket → Anchor
10 - Seal
q   Renew
11 - Clutch master cylinder
q   Removing and installing → Chapter
12 - Clutch position sender -G476-
q   Clutch pedal switch -F36- and clutch pedal switch for engine start -F194- are integrated
q   Can only be renewed together with clutch master cylinder → Item

   

Removing and installing over-centre spring > < Servicing clutch mechanism