audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
6-speed manual gearbox 0B3, front-wheel drive > < Renewing ball bearing for flange shaft (rear)

A4 Mk3

Renewing ball bearing for centre differential
   
Renewing ball bearing for centre differential
Special tools and workshop equipment required
t  Thrust plate -VW 401-
t  Thrust plate -VW 402-
t  Press tool -VW 412-
t  Press tool -VW 432-
t  Assembly tool -3350-
t  Splitter 22 ... 115 mm -Kukko 17/2-

   
Procedure
–  Remove centre differential housing → Chapter.
–  Pull centre differential -1- off output shaft towards the rear.
  Note
Different versions of centre differential -1- depending on equipment version.
  A39-10341
Pressing ball bearing off centre differential
A - Splitter 22 ... 115 mm -Kukko 17/2-
The collar of press tool -VW 432- points towards ball bearing.
  A39-10343
Pressing ball bearing onto centre differential
  A39-10345

6-speed manual gearbox 0B3, front-wheel drive > < Renewing ball bearing for flange shaft (rear)