audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Additional work required after renewing four-wheel drive control unitJ492 > < Electrical/electronic components and fitting locations

A4 Mk3

Removing and installing four-wheel drive control unitJ492
Removing and installing four-wheel drive control unit -J492-
  Note
t  Fitting locations of four-wheel drive control unit -J492- → Item
t  The removal and installation procedures are described for the A4 saloon.
l  Ignition is switched off.
–  Remove luggage compartment floor covering.
–  Remove cover and mounting for vehicle tool kit.
   
–  Remove four-wheel drive control unit -J492--A- from bracket -C-.
–  Release connector -B- and unplug from four-wheel drive control unit -J492-.
–  Installation of four-wheel drive control unit -J492- is carried out in reverse order of removal.
l  Additional work is required if four-wheel drive control unit -J492- has been renewed → Chapter „Additional work required after renewing four-wheel drive control unit -J492-“.
  A39-10392

Additional work required after renewing four-wheel drive control unitJ492 > < Electrical/electronic components and fitting locations