A4 Mk3
| Oil filter bracket and engine oil cooler - exploded view |
| 1 - | Gasket |
| q | Renew |
| 2 - | Bolt |
| q | 15 Nm + 90° |
| q | Renew |
| q | First fit bolt on top left and bolt on bottom right, then tighten the four bolts diagonally |
| 3 - | Oil filter bracket |
| q | Ensure clearance from surrounding components |
| 4 - | Seal |
| q | Renew |
| 5 - | Connection |
| q | 30 Nm |
| 6 - | Oil supply line |
| q | 22 Nm |
| q | To turbocharger |
| 7 - | Oil pressure switch -F1- |
| q | 22 Nm |
| q | Identification: brown |
| q | 0.7 bar |
| q | In case of leakage, cut open seal and renew |
| q | Checking → Chapter |
| 8 - | Sealing cap |
| q | 25 Nm |
| 9 - | O-ring |
| q | Renew |
| 10 - | Oil filter element |
| q | See note |
| q | Observe change intervals |
| 11 - | Seal |
| q | Renew |
| q | Lubricate before installing |
| q | Engage in lugs on engine oil cooler |
| 12 - | Engine oil cooler |
| q | Ensure clearance from surrounding components |
| 13 - | Seal |
| q | Renew |
| q | Installation position → Fig. |
| 14 - | Screw plug |
| q | 25 Nm |
| 15 - | Bolt |
| q | 10 Nm |
| 16 - | Bracket |
| q | For wiring harness |
|
|
