audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing exhaust gas temperature sender 4G648 > < Removing and installing exhaust gas temperature sender 1G235

A4 Mk3

Removing and installing exhaust gas temperature sender 3G495
Removing and installing exhaust gas temperature sender 3 -G495-
Special tools and workshop equipment required
   
t  Tool set, 17 mm -T10395-
  W00-10718
Removing
  Note
Fit all cable ties in the original positions when installing.
–  Remove engine cover panel -arrows-.
  A10-11353
–  Detach electrical connector -3- from bracket.
–  Unplug electrical connector -4- and move clear.
–  Remove exhaust gas temperature sender 3 -G495--item 2-.
  Note
Disregard -item 1-.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torques → Chapter „Exhaust gas temperature senders - exploded view“
  Caution
Risk of malfunctions caused by improperly secured exhaust gas temperature senders.
The threads of the exhaust gas temperature senders -G495- and -G648- are coated. It is important that you do NOT grease them additionally with high-temperature paste and that you tighten them to the specified torque.
  A26-11023

Removing and installing exhaust gas temperature sender 4G648 > < Removing and installing exhaust gas temperature sender 1G235