| Measuring radial clearance of crankshaft |
| Special tools and workshop equipment required |
| –
| Remove retaining frame and clean bearing journals. |
| –
| Place a length of Plastigage corresponding to the width of the bearing on the bearing journal or in the bearing shell. |
| l
| The Plastigage must be positioned in the centre of the bearing shell |
| –
| Fit retaining frame and tighten to 30 Nm without rotating crankshaft. |
| –
| Remove retaining frame again. |
| –
| Compare width of Plastigage with measurement scale. |
|
|
|
