A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
-
Measure the distance - a - between both threaded bolts in shift mechanism.
‹› Specification: Dimension a = 85 mm
‹› Measured from center of threaded bolt to center of threaded bolt.
-
If this is not the case, adjust distance - a - as follows:
-
Loosen bolt - arrow - for push rod.
‹› The rear push rod in the shift mechanism must move easily back and forth on the sliding piece.
-
Set dimension - a - by moving the rear push rod in the shift mechanism.
-
Tighten push rod bolt - arrow - to 23 Nm.
-
Loosen selector rod bolt - arrow -.