A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
‹› If, by cutting out the damaged wire section, both ends of the vehicle-specific single wire are too short for a repair using a single crimp connector,
insert a repair wire section of matching length with two crimp connections => [ Wire, 0.35 mm or Larger with Intermediate Wire Section,
Repairing ].
-
Adjust the sliding stop in the Wire Stripper ( VAS 1978/3) pliers jaws to 6 to 7 mm for the wire to be stripped.
-
Insert wire end from front up to stop into jaws of pliers and squeeze the pliers completely.
-
Open pliers again and remove the stripped wire end.
-
For the repair, use a suitable crimp connector form the Wiring Harness Repair Set (VAS 1978A).
-
Use the Crimping Pliers (Base Tool) (VAS 1978/1-2 ) to press the crimp connector.