A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Disconnect the electrical harness connector of the Camshaft Position (CMP) Sensor (G40) to be tested.
-
Switch the ignition on.
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor electrical harness connector terminals 1 to 3 for voltage.
Specified value: about 5.0 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to Fuel Injection and Ignition Repair Information.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623 ). Refer to => [ ECM, Removing and Installing ] See: Engine Control Module/Service and
Repair/ECM, Removing and Installing.
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor electrical harness connector to the Engine Control Module (ECM) (J623)
electrical harness connector T60 for an open circuit.