A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Specified value: 1.5 ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the wiring connection for damage, corrosion, lose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was OK:
-
Replace the Camshaft Position (CMP) Sensor (G40 ) Refer to Fuel Injection and Ignition Repair Information.
If no malfunction is found in the wiring and voltage supply was not OK:
-
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ ECM, Removing and Installing ] See: Engine Control Module/Service and
Repair/ECM, Removing and Installing.