A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
‹› Always replace
‹› Tighten bolts only in curb weight position
5 - Combi-bolt
‹› 85 Nm plus an additional 90° turn
‹› Always replace
6 - Lower spring support
‹› Spring end rotated up to stop
7 - Coil spring
‹› Note different vehicle versions, see vehicle data plate.=> [ Explanations of the production
control numbers (PR number) ] See: Suspension/Application and ID
‹› Removing and installing, refer to => [ Coil Spring ] See: Suspension/Suspension Spring ( Coil / Leaf )/Service and Repair
8 - Upper spring support
9 - Upper spring support
‹› Only for heavy duty suspension
10 - Combi-bolt
‹› 85 Nm plus an additional 90°
‹› Always replace
11 - Transverse Link
‹› Removing and installing, refer to => [ Transverse Link ] See: Suspension/Control Arm/Service and Repair/Rear Suspension/Transverse Link
‹› Replace bearing, refer to => [ Transverse Link Bracket ] See: Suspension/Control Arm/Service and Repair/Rear Suspension/Transverse Link
Bracket
12 - Eccentric bolt
‹› Vehicle alignment must be performed after loosening, refer to => [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel Alignment
‹› Do not turn more than 90° left or right (that is, smallest to largest possible adjustment)
13 - Washer
14 - Self-locking nut
‹› 85 Nm plus an additional 90°
‹› Always replace
‹› Tighten bolts only in curb weight position
15 - Tie Rod
‹› Various versions
‹› Removing and installing, refer to => [ Tie Rod ] See: Tie Rod
‹› Perform an axle alignment after installing, refer to => [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel Alignment.
16 - Stone protection plate