A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Clutch Disc: Removal and Replacement
Conventional Clutch, Servicing
Conventional clutch, servicing, 02X, 6-Speed Four-Wheel Drive M/T
1 - Flywheel/dual mass flywheel
^
Ensure that dowel pins fit tightly
^
Contact surface for clutch lining must be free of grooves, oil and grease
2 - Bolt for flywheel
^
Always replace
^
Bolt length: 22.5 mm; 60 Nm plus an additional 90° 1/4 turn
^
Bolt length: 43 mm; 60 Nm plus an additional 180° 1/2 turn
3 - Clutch plate
^
Installation position: Clutch lining must make full contact with flywheel
^
Marking "Getriebeseite" (transmission side), if provided, faces pressure plate/transmission.
^
Coil springs (damper assembly) point toward pressure plate and transmission
^
Centralize
4 - Pressure plate
^
Removing and installing
^
Check ends of diaphragm spring
^
Check spring connection and rivets
^
Check wire ring
5 - Bolt -22 Nm-
^
Loosen and tighten gradually in several stages and in diagonal sequence
6 - Needle bearing