A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
/Page-1984002.png)
-
Use press lever - RMV outside mirror 80-200 to pry off rear attachments - A - of heat shield for drive shaft.
-
Remove securing bolts - B - for center bearing.
Note:
^
When removing the securing bolts support the drive shaft by hand. Do not bend drive shaft.
-
Remove heat shield. Continue supporting drive shaft.
-
Screw in securing bolts for center bearing again hand-tight.
-
Remove heat shield for drive shaft off transmission - arrows -.
-
Check for a factory marking (colored dot) on drive shaft and on drive shaft flange on final drive at the rear. If no colored dot is present, mark the
position of the drive shaft flange -arrow A- relative to the rear final drive - arrow B - with a colored dot.
-
Engage alignment fixture-4W dr. shaft 3139 and tighten plastic nuts.
