A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Pry out flange shaft oil seal - arrow - using an assembly lever.
Installing
-
Lightly oil outer circumference of new oil seal.
-
Drive new oil seal for flange shaft using driver 2062; keep seal straight when installing.
^
Insertion depth: 5.50 ± 0.15 mm below top of cover.
-
Pack space between sealing lip and dust lip half-full with sealing grease G052128A1.
Note:
Inspect polygon bearings for visible damage - 2 -.
^
If the polygon bearings - 2 - do not run smoothly with the flange shaft removed, this does not necessarily indicate that the bearings are faulty. A
test for noisy bearings can only be performed with the bearings installed.
^
The polygon bearings can only be replaced together with the flange shaft.
^
Always replace circlip for flange shaft - 5 -.