A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Remove push rod - 1 - by unbolting socket head hex bolt.
-
Remove the nut - arrow - and remove the selector shaft lever from the transmission selector shaft.
-
Remove shift mechanism to the rear.
Installing
Install in reverse sequence; note the following points:
‹› Seals and self-locking nuts must be replaced.
-
Install and tighten the selector shaft lever - arrow -. Tightening specification => [ (Item 24) Cap nut, 20 Nm ] See: Service and Repair/Removal
and Replacement/02XA Transmission/Selector Mechanism Assembly Overview.