audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Heat Shields|Page 10812 > < Heat Shields|Page 10810
Page 5
background image

Before installing, center steering gear using steering centering bolt VAS 6224.
-

To do this, remove hex socket head bolt - 1 - on steering gear.

-

Move steering rack until center marking (indentation) on rack - arrow - aligns with threaded hole - 2 - Screw in steering centering bolt VAS 6224
hand-tight.

-

Apply lubricant G 052 745 A3 to steering gear where rubber boot for bulkhead is attached.

-

Position steering gear on plenum chamber (2nd mechanic required).

Note:  

^

Make sure threads and contact surfaces of bolts are free from oil and grease.

-

Insert bolt - 1 - but do not tighten.

-

Swivel steering gear forward in direction of travel on drivers side.

-

Connect return hose and tighten banjo bolt - 2 - (22 mm).

-

Connect pressure hose and tighten banjo bolt - 1 - (19 mm)

Note:  

^

Always use new seals for banjo bolts.

^

Pressure hose and return hose must not touch each other or come into contact with other components.

For certain engine/transmission versions, the banjo bolts can only be tightened from wheel housing.

Heat Shields|Page 10812 > < Heat Shields|Page 10810