A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
-
Drive in flanged shaft seal.
-
Remove washer after inserting seal.
-
Pack space between sealing and dust lips with sealing grease G 052 128 A1.
-
Press in flanged shaft.
-
Install circlip onto flanged shaft.
-
Lightly oil O-ring and insert into groove of bearing housing.
-
Insert dished washer and shims into bearing housing.
^
Installation position, Item 9.
-
Install spiral spring onto flanged shaft.
-
Tighten bolts attaching bearing housing in stages and diagonally.
-
Bolt on driveshaft.