A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
-
Push the final drive upward over the driveshaft - 1 -. While doing this, install the press piece (T40186/1) and the spindle (T10254/5) and nut
(T10254/4) (a 2nd technician is necessary).
4
(T10254/5). The spindle pins face downward.
5
(T10254/4)
6
(T40186/1)
-
When removing or installing the rubber bonded bushing, make sure the spindle - 4 - does not contact the threaded hole - 3 - in the final drive.
When drilling through the inner core of the bonded rubber bushing, it is possible the (T10254/5) may not be drilled all the way through, if so, it must
be drilled again.
‹› Drill several times in steps using a different drill bit diameter each time.
‹› While drilling, make sure drill does not damage the threaded hole - 3 - in the final drive; if necessary place a suitable object in between.
CAUTION!
Wear protective eyewear while drilling.
-
Position the drill - 1 - on the bonded rubber bushing - 2 - as illustrated and drill the hole in several steps.