A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
Outer Constant Velocity Joint, 88 mm or 100 mm, Installing
-
Slide joint protective boot onto drive axle.
Joints and protective joint boots must be free of grease.
-
Position protective joint boot between - arrows -.
1
Circlip (snap ring), must be replaced.
Outer Constant Velocity Joint, 88 mm
-
Apply 40 grams of joint grease to inside of joint.
Outer Constant Velocity Joint, 100 mm
-
Apply 70 grams of joint grease to inside of joint.
Continuation for Both Constant Velocity Joints
-
Before installing joint piece, splines - A - must be lightly coated with grease used in joint.
-
Insert sealing ring in groove on shaft.
-
Slide on CV joint up to sealing ring.