A4 Quattro Wagon L4-2.0L Turbo (CAEB) (2009)
/Page-1372007.png)
-
Use (V.A.G 1682) as shown in illustration. Be sure that edges of clamping pliers are seated in corners - arrows B - of clamp.
-
Tighten the clamp by turning the spindle using a torque wrench - C - (do not tilt the pliers).
‹› A stainless steel clamp must be used due to the hardness of the CV boot material (compared to rubber). This clamp can only be tensioned using the
(V.A.G 1682).
‹› Tightening Specifications 20 Nm.
‹› Use torque wrench with 5 to 50 Nm range (e.g. (V.A.G 1331 )).
‹› Make sure the spindle threads on the pliers - A - move freely. Grease with MoS2 grease if necessary.
‹› If the thread is tight e.g. dirty, the required tensioning force for the hose clamp will not be achieved in spite of correct torque specification settings.