A4 Quattro Wagon V6-3.0L (AVK) (2002)
2
-
Bolts
-
2.5 Nm
3
-
Connector on Seat Occupied Recognition Control Module -J706
-
Must not be separated under any circumstances.
4
-
Seat Occupied Recognition Pressure Sensor -G452
5
-
Pressure hose
6
-
Harness connector between service kit and seat wiring harness
7
-
Connector on Seat Occupied Recognition Pressure Sensor -G452
-
Must not be separated under any circumstances.
8
-
Guide clip
9
-
Retaining bracket
Service Kit, Removing
-
Fold the cushion - 5 - upward.
NOTE:
-
The cushion is included as part of the service kit.
-
Clip - 4 - must not be separated.
-
The hard foam insert in the crease is not included in the service kit.
-
Remove clips - 2 - and - 3 - (Qty. 2).
-
Carefully pull mat for seat occupied recognition - 1 - with upholstery - 5 - upward, when doing this guide Seat Occupied Recognition Pressure
Sensor -G452- and Seat Occupied Recognition Control Module -J706-through seat pan without disconnecting harness connectors.
-
Remove the complete service kit.
CAUTION: The pressure hose and the Seat Occupied Recognition Mat - 1 - must not be kinked under any circumstances during repairs.
Service kit, installing
NOTE: The hard foam insert in the crease is not included in the service kit. Therefore, reuse the hard foam insert again in the seat crease.
-
Guide the Seat Occupied Recognition Pressure Sensor -G452 and Seat Occupied Recognition Control Module -J706 from above through the seat
pan without separating the electrical connections.
-
Pull the crease between seat pan and Seat Occupied Recognition Mat - 1 - so that it is smooth (free of folds).
-
Secure the Seat Occupied Recognition Mat - 1 - with the clips - 2 - and - 3 - (Qty. 2).