A4 Sedan V6-3.2L (BKH) (2007)
-
When installing, make sure that the cylinder head gaskets do not become damaged. A damaged gasket must be replaced.
-
Tighten bolts as follows:
All:
Further installation is in reverse order of removal, noting the following:
-
Install oil filter housing. Refer to => [ Oil Filter Housing ] See: Engine Lubrication/Oil Cooler/Service and Repair/Oil Filter Housing.
-
Install left and right timing chain covers. Refer to => [ Installing ] See: Left and Right Timing Chain Covers.
-
Install crankshaft seal, timing chain side. Refer to => [ Crankshaft Seal, Timing Chain Side, Replacing ] See: Seals and Gaskets/Crankshaft Main
Bearing Seal/Service and Repair/Crankshaft Seal, Timing Chain Side, Replacing.
-
Manual Transmission. Install dual mass flywheel. Refer to => [ Dual Mass Flywheel ] See: Transmission and Drivetrain/Flywheel/Service and
Repair/Dual Mass Flywheel and clutch pressure plate => Manual Transmission/Transaxle See: Transmission and Drivetrain/Manual
Transmission/Transaxle
-
Vehicles with multitronic transmission: Install flywheel. Refer to => [ Flywheel ] See: Transmission and Drivetrain/Flex Plate/Service and
Repair/Flywheel and damper unit => [ Damper Unit ] See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and
Repair/Damper Unit.
-
Vehicles with automatic transmission: Install drive plate. Refer to => [ Drive Plate ] See: Transmission and Drivetrain/Flex Plate/Service and
Repair/Drive Plate.
-
Add engine oil and check oil level.
Tightening Specifications