A4 Sedan V6-3.2L (BKH) (2007)
/Page-713006.png)
Note:
^
After removing shut-off valve, ATF drips out lightly.
-
Replace and tighten ATF check plug.
^
Tightening torque: 20 Nm.
Note:
^
At the latest at 45°C(50°C for hot countries) the ATF check plug -B- must be installed again.
^
At an ATF temperature above 45°C, too much ATF flows out due to heat up and the transmission is not filled sufficiently!
-
Press <-- button to end function "08 - Read measured value block".
-
Select "06 - End output".
-
Switch off ignition and disconnect Data Link Connector (DLC).