A4 Sedan V6-3.2L (BKH) (2007)
/Page-1539002.png)
-
Position the (T10133/2A) in the groove on the fuel injector.
-
Then position the (T10133/16) and remove the fuel injector by loosening the bolt - 1 -.
‹› When setting the puller in place, the radial adjustment can be destroyed, because the retaining tabs break.
-
Carefully remove the old combustion chamber seal - arrow -, thereby cutting seal open with a knife or spreading seal open with a small
screwdriver and pulling it forward and off.
-
Make sure that the groove of the fuel injector does not become damaged. If the groove is damage, the fuel injector must be replaced.